Aerospace Honer/Assembler

Aerospace Shop looking for Aerospace Honer/Assembler

King Machine specializes in the manufacture of precision CNC machined parts and assemblies for the global aerospace industry. We are committed to Customer satisfaction through Employee involvement and continuous improvement which results in sustained performance in quality, delivery, and cost. Join our team and be part of the Global Aerospace Industry as we take off into the future!

Industry Leading Benefits

• Group Medical, Dental and Vision Insurance. King pays 83% of the Employee & 73% of Dependent monthly premiums. Effective the 1st of the month following 30 days of employment.
• Long Term Disability, Life Insurance & EAP paid 100% by King Machine.
• Voluntary Life insurance with the employee paying 100% of the premium.
• 401(k) plan with 100 % Company Match Effective the 1st of the month following 60 days of employment.
• PTO & Holiday pay - Eligible upon hire

Pay Range $22-$28/ hour

Duties and Responsibilities:

• Primary responsibility: Honing (hole sizing). Setting up Sunnen horizontal honing machine to size bushings and bores to very tight measurements per engineering drawings
• Install units, parts, equipment, and components in structural assembly, according to blueprints and specifications, using hand tools and power tools.
• Bolt, screw, or rivet accessories to fasten, support, or hang components and subassemblies.
• Drill holes in structure and subassemblies, and attaches brackets, hinges, or clips to secure installation or to fasten subassemblies.
• Locate and mark reference points and holes for installation of parts and components, using jigs, templates, and measuring instruments.
• Inspect and test installed units, parts, and equipment for fit, performance, and compliance with standards, using measuring instruments and test equipment.
• Position and aligns subassemblies in jigs or fixtures, using measuring instruments, following blueprint lines and index points.
• Cut, trim, and file parts, and verify fitting tolerances to prepare for installation.
• Install bushings using liquid nitrogen or presses as required.
• Apply sealants or paint per customer specifications using proper safety devices.
• Uses shop equipment needed to complete operations, such as C-squeeze, arbor presses, ground stud puller, cherry pullers, and shop hand tools.
• Verify conformance of finished work piece to specifications using standard measuring tools as required.
• Read and interpret manufacturing drawings at basic level.

Required Attributes:

• Demonstrates a good attitude toward work.
• Reliable - arrives on time to work with good attendance.
• Follows instructions and demonstrates strong attention to detail.
• Communicates well verbally and in writing.
• Mechanically inclined, with good manual dexterity.

Full Time position: Shift Hours: Monday - Thursday 6 AM to 4:30 PM Overtime as needed

Come join the King TEAM!

King Machine, LLC is an Equal Opportunity Employer

This offer is contingent upon successfully passing a pre-employment drug screening. The drug screening is a 10 panel less THC, so THC is not tested for.

This position requires access to controlled data or information and therefore only US persons will be considered. As a US Department of Defense contractor we are bound by the International Traffic in Arms Regulations ( ITAR ).